Analog Devices
ADG729BRUZ
Analog Multiplexer Dual 4: 1 16-Pin TSSOP Tube
Цена от 311,74 ₽ до 634,95 ₽
Наличие Analog Devices ADG729BRUZ на складах.
Дистрибьютор
Наличие и цена
На складе 492 шт.
MOQ 1 шт.
Обновлено 19:14 27.01.2021
Упаковка Tube На складе 384 шт.
MOQ 1 шт.
Обновлено 14:07 28.01.2021
Упаковка Tube На складе 100 шт.
Обновлено 10:24 14.01.2021
На складе 12 шт.
Обновлено 11:26 28.01.2021
Цена по запросу.
На складе 357 шт.
Обновлено 14:25 26.01.2021
Цена по запросу.
Технические характеристики Analog Devices ADG729BRUZ, атрибуты и параметры.
Пропускная способность:
100 MHz
Тип корпуса / Кейс:
TSSOP, SOP
Case/Package (SI):
SOP
Contacts Type:
4PST
Lead-Free Status:
Lead Free
Статус жизненного цикла:
Active
Mounting Style:
Surface Mount
Negative Supply Voltage:
0.00 V (min)
Количество бит:
4
Количество каналов:
4
Рабочая Температура:
-40.0 °C to 85.0 °C
Упаковка:
Tube, Bulk
Количество выводов:
16
Positive Supply Voltage:
5.50 V (max)
Рассеяние мощности:
100 µW
Drain to Source Resistance (on) (Rds):
2.50 Ω
REACH SVHC Compliance:
No SVHC
RoHS:
Compliant
Supply Current:
10.0 µA
Supply Voltage (DC):
5.50 V (max)
- Analog Multiplexer Dual 4:1 16-Pin TSSOP Tube
- Аналоговый коммутатор / мультиплексор (Mux) IC
- Тип аналогового мультиплексора: дифференциальный
- Источник напряжения питания: одиночный
- On State Resistance Max:2.5ohm
- Мин. Напряжение питания: 2,7 В
- Максимальное напряжение питания: 5,5 В
- Тип завершения: SMD
- Package/Case:16-TSSOP
- Соответствует RoHS: Да
- The ADG729 is a CMOS analog matrix switch with a serially controlled 2-wire interface. It is a dual 4-channel matrix switch. On resistance is closely matched between switches and very flat over the full signal range. This part can operate equally well as a multiplexer, demultiplexer or switch array and the input signal range extends to the supplies. The ADG728 and ADG729 utilize a 2-wire serial interface that is compatible with the I2C™ interface standard. Both have two external address pins (A0 and A1). This allows the 2 LSBs of the 7-bit slave address to be set by the user. Four of each of the devices can be connected to the one bus. The ADG728 also has a RESET pin that should be tied high if not in use. Each channel is controlled by one bit of an 8-bit word. This means that these devices may be used in a number of different configurations
- all, any, or none of the channels may be on at any one time. On power-up of the device, all switches will be in the OFF condition and the internal shift register will contain all zeros. All channels exhibit break-before-make switching action preventing momentary shorting when switching channels. The ADG728 and ADG729 are available in 16-lead TSSOP packages. Product Highlights 2-Wire Serial Interface. Single Supply Operation. The ADG728 and ADG729 are fully specified and guaranteed with 3 V and 5 V supply rails. Low On Resistance 2.5 O typical. Any configuration of switches may be on at any one time. Guaranteed Break-Before-Make Switching Action. Small 16-Lead TSSOP Package. Applications Data Acquisition Systems Communications Systems Relay Placement Audio and Video Switching Automatic Test Equipment
