Наличие Infineon TLE4998P3XALA1 на складах.
Склад
Наличие и цена
В наличии до 1654 шт.
MOQ от 1 шт.
Цена от 1 474,78 ₽ до 3 396,89 ₽
На складе 1654 шт.
MOQ 1 шт.
Обновлено 15:33 18.02.2021
На складе 220 шт.
Обновлено 21:49 15.02.2021
Цена по запросу.
На складе 800 шт.
Обновлено 14:03 18.02.2021
Цена по запросу.
В наличии до 4000 шт.
MOQ от 1 шт.
Цена от 225,70 ₽ до 667,69 ₽
На складе 2345 шт.
MOQ 155 шт.
Обновлено 02:48 19.02.2021
На складе 2345 шт.
Обновлено 09:57 19.02.2021
На складе 702 шт.
MOQ 1 шт.
Обновлено 19:37 19.02.2021
Упаковка Ammo Pack На складе 742 шт.
MOQ 1 шт.
Обновлено 19:37 19.02.2021
Упаковка Ammo Pack На складе 2000 шт.
MOQ 2000 шт.
Обновлено 01:42 20.02.2021
Упаковка Ammo На складе 4 шт.
MOQ 1 шт.
Обновлено 14:19 19.02.2021
Упаковка Cut Tape На складе 1650 шт.
MOQ 1 шт.
Обновлено 03:58 19.02.2021
На складе 4000 шт.
MOQ 2000 шт.
Обновлено 19:10 18.02.2021
На складе 2 шт.
Обновлено 22:46 09.02.2021
Цена по запросу.
На складе 1540 шт.
Обновлено 00:25 19.02.2021
Цена по запросу.
В наличии до 1650 шт.
MOQ от 1 шт.
Цена от 324,38 ₽ до 771,96 ₽
На складе 1650 шт.
MOQ 1 шт.
Обновлено 14:53 18.02.2021
Технические характеристики Infineon TLE4998P3XALA1, атрибуты и параметры.
Lead-Free Status:
Lead Free
Mounting Style:
Through Hole
Рабочая Температура:
-40.0 °C (min)
Выходной ток:
5.00 A
Упаковка:
Ammo Pack
RoHS:
Compliant
Supply Voltage (DC):
4.50 V (min), 5.50 V (max)
- Hall Effect Sensor 5mA Unipolar/Bipolar 5V 3-Pin SSO Ammo Pack
- TLE4998P3 Series 5.5 V 8 mA Programmable Linear Hall Sensor - PG-SSO-3-10
- Hall Effect Sensor, 50mT Min, 200mT Max, BICMOS, Plastic/epoxy, Square, 3 Pin, Through Hole Mount
- The linear Hall IC TLE4998P has been designed specifically to meet the requirements of highly accurate rotation and position detection, as well as for current measurement applications. The sensor provides a digital PWM signal, which is ideally suited for direct decoding by any unit measuring a duty cycle of a rectangular signal (usually a timer/capture unit in a microcontroller). Furthermore, it is possible to attach an external lowpass filter, which allows an A/D conversion using the sensor supply voltage as a reference. The output stage is an open-drain driver pulling the output pad to low only. Therefore, the high level must be obtained by an external pull-up resistor. This output type has the advantage that the receiver may use even a lower supply voltage (e.g. 3.3 V). In this case, the pull-up resistor must be connected to the given receiver supply.The IC is produced in BiCMOS technology with high voltage capability, also providing reverse polarity protection. Digital signal processing, using a 16-bit DSP architecture together with digital temperature compensation, guarantees excellent long-time stability as compared to analog compensation methods. While the overall resolution is 16 bits, some internal stages work with resolutions up to 20 bits. The PWM output frequency can be selected within the range of 122 Hz up to 1953 Hz. | Summary of Features: SPC (Short PWM Code) protocol with enhanced interface features based on SENT (Single Edge Nibble Transmission,defined by SAE J2716)
- 20-bit Digital Signal Processing (DSP)
- Digital temperature compensation
- 16-bit overall resolution
- Operates within automotive temperature range
- Low drift of output signal over temperature and lifetime
- Programmable parameters stored in EEPROM with single-bit error correction: SPC protocol modes: synchronous transmission, dynamic range selection, ID selection mode,SPC unit time,Magnetic range and sensitivity (gain), polarity of the output slope,Offset,Bandwidth,Clamping levels,Customer temperature compensation coefficients,Memory lock Re-programmable until memory lock
- Supply voltage 4.5 - 5.5 V (4.1 - 16 V in extended range)
- Operation between -200 mT and +200 mT within three ranges
- Reverse-polarity and overvoltage protection for all pins
- Output short-circuit protection
- On-board diagnostics (overvoltage, EEPROM error, start up)
- Output of internal magnetic field values and temperature
- Programming and operation of multiple sensors with common power supply
- Two-point calibration of magnetic transfer function without iteration steps
- High immunity against mechanical stress, EMC, ESD | Target Applications: Robust replacement of potentiometers,No mechanical abrasion,Resistant to humidity, temperature, pollution and vibration
- Linear and angular position sensing in automotive applications such as pedal position, suspension control, throttle position, headlight levelling, and steering torque sensing
- Sensing of high current for battery management, motor control,and electronic fuses
